![background image](http://html1.mh-extra.com/html/smc-networks/6726al2-fiche/6726al2-fiche_management-manual_1300177460.webp)
C
OMMAND
L
INE
I
NTERFACE
4-220
garp timer
This command sets the values for the join, leave and leaveall timers. Use
the
no
form to restore the timers’ default values.
Syntax
garp timer
{
join
|
leave
|
leaveall
}
timer_value
no garp timer
{
join
|
leave
|
leaveall
}
• {
join
|
leave
|
leaveall
} - Which timer to set.
•
timer_value
- Value of timer.
Ranges:
- join: 20-1000 centiseconds
- leave: 60-3000 centiseconds
- leavall: 500-18000 centiseconds
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Group Address Registration Protocol is used by GVRP and GMRP to
register or deregister client attributes for client services within a
bridged LAN. The default values for the GARP timers are
independent of the media access method or data rate. These values
should not be changed unless you are experiencing difficulties with
GMRP or GVRP registration/deregistration.
• Timer values are applied to GVRP for all the ports on all VLANs.
• Timer values must meet the following restrictions:
- leave >= (2 x join)
- leaveall > leave
Note:
Set GVRP timers on all Layer 2 devices connected in the same
network to the same values. Otherwise, GVRP may not operate
successfully.
Summary of Contents for 6726AL2 FICHE
