Sirona galileos, Service Manual, Page: 99 / 388

61 25 665 D3437
D3437
.
076.01.15
.
02 06.2012 99
Sirona Dental Systems GmbH 5 Messages
Service Manual GALILEOS 5.5 List of error messages
båÖäáëÜ
E1 10 07 GALILEOS
* As of X-ray detector serial number 5000, cable L28 can no longer be
replaced individually.
E1 10 20/21/22 GALILEOS
Error code Description Actions required see
E1 10 07 The unit is not ready for operation.
Following longer periods of disuse
(> 200 h), a preparation time of up to
ten minutes is required for the
sensor after the unit is switched on.
During this period, the message
"Sensor being prepared" or S150 is
displayed. During this time the unit
is not ready for operation. If
exposure readiness is reached
during this time, error message E1
10 07 appears.
If this error is displayed after a longer period of
disuse and the attainment of exposure
readiness ...
● Acknowledge the error and wait until the
"Sensor being prepared" message goes
out.
If this error is displayed without attainment of
exposure readiness ...
● Check cable L13 between board DX11
and board DX89, replace if necessary.
● Check cable L28 between the camera
head and board DX89 (in the X-ray
detector), replace if necessary.
● Check cable L27 (in the X-ray detector),
replace if necessary.
● Replace board DX89.
● Replace board DX1.
● Replace the X-ray detector.
● Replace board DX11.
S. [ → 141],
S. [ → 362],
S. [ → 319]
Error code Description Actions required see
E1 10 20
E1 10 21
E1 10 22
Board DX11 does not have valid
data about the X-ray detector.
Board DX11 does not have valid
data about board DX89.
X-ray detector was replaced and
must be registered in the system.
● Perform service routine S009.7 (copy data
from DX89 to board DX11).
● Perform service routine S009.7 (copy data
from DX89 to board DX11).
● Perform service routine S009.7 (copy data
from DX89 to board DX11).
● Calibrate the unit.
S. [ → 245],
S. [ → 155]