Siemens SIMATIC FM 453, Manual

Page: 351 / 380

11-35
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Table 11-8 General Data Errors, Machine Data Errors, Traversing Program Errors, continued
Cl.
Message/
Display
Error Message,
Error Analysis and Elimination
No.
Traversing program errors Error response: “Warning”
8 (08) 26 (1A) G function 3 unacceptable CBS
Cause
S
The number programmed as G function 3 is not allowed.
S
External block change (G50) was programmed in a block to-
gether with continuous operation for setting actual value
on the fly (G88/89).
S
A tool offset (G43, G44) was called up without D number.
S
In selecting a D number, the direction specification is missing
for the tool offset (G43, G44).
or
DB
Effect Program/block not stored.
Elimina-
tion Correct program, per cause.
8 (08) 27 (1B) M function unacceptable CBS
Cause
S
The number programmed as M function is not allowed.
S
At least two of the M functions M0, M2, M18, M30, which
cancel each other out, are found in one block.
or
DB
Effect Program/block not stored.
Elimina-
tion Correct program, per cause.
8 (08) 28 (1C) Position/dwell time missing CBS
Cause
S
No dwell time specified in block with G04.
S
Target position missing with external block change (G50).
S
No new actual value programmed for the function continuous
operation with setting actual value on the fly (G88/89).
or
DB
Effect Program/block not stored.
Elimina-
tion Correct program, per cause.
8 (08) 29 (1D) Incorrect D-NO (>20) CBS
Cause The number for tool offset is greater than 20.
or
DB
Effect Program/block not stored.
DB
Elimina-
tion Correct program, per cause.
8 (08) 30 (1E)
Error, subroutine
CBS
Cause Subroutine without callup number.
or
DB
Effect Program is not stored.
DB
Elimina-
tion Correct program, per cause.
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
Troubleshooting