Siemens SIMATIC FM 453, Manual

Page: 332 / 380

11-16
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Table 11-6 Operator Control Errors, continued
Cl.
Message/
Display
Error Message,
Error Analysis and Elimination
No.
Operator control errors Error response : “Feed STOP” see Table 11-2
2 (02) 12 (0C) Axis movement not possible CBS
Cause Due to an unacknowledged error, no drive enable or stop, a traverse
command was triggered.
Effect
Elimina-
tion Restore traverse command and switch acknowledge error or Stop to
inactive, or enable drive.
2 (02) 13 (0D) Incremental value not in place CBS
Cause The setpoints defined by the operating mode parameters are mis-
sing or a change in incremental dimensions occurred when the op-
erating mode started.
Effect
Elimina-
tion Parameterize and read in setpoint parameters
2 (02) 14 (0E) No program preselected CBS
Cause No program preselected at “Start.”
Effect
Elimina-
tion First preselect program then start.
2 (02) 15 (0F) Digital input not activated CBS
Cause The programmed target was reached in a block with external block
change (G50).
Effect
Elimina-
tion Check programming (MD34) and connection of digital input.
2 (02) 16 (10) Measurement function undefined CBS
Cause Length measurement and inprocess measurement selected simulta-
neously
Effect No measurement function effective.
Elimina-
tion Reselect one of the two measurement functions.
2 (02) 21 (15)
Activate machine data not allowed
CBS
Cause “Processing in progress” is still active.
Effect Activate machine data not executed.
Elimina-
tion Terminate processing, repeat activation.
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
Troubleshooting