Siemens SENTRON PAC4200, Manual, Page: 115 / 252

Operator control
8.2 Operator input steps
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
115
8.2.5 Operator input steps in edit mode of the device settings
Entering the password
If device protection is switched on, the device demands input of the valid password.
You can find information on password management in the "Password management" chapter.
Change value
Switching options ON/OFF
F4
switches a function or status ON/OFF.
F4 switches between several options that cannot be effective at the same time.
The setting takes effect immediately. Saving with F4 no longer applies.
Selecting from several settings
F2
scrolls up through the range of selectable settings.
F3 scrolls down through the range of selectable settings.
The last value in the available set of values is followed again by the first value.
Incrementing or decrementing a value
F2
increases the value in increments of 1.
F3 decreases the value in decrements of 1.
The highest value of the available set of values is followed again by the lowest.
Defining multi-digit values
If F3
is available, the digits of a value can be changed, e.g. specific address digits of
an address value.
F3
runs through the digits of the value from left to right.
F2 increments the value at the selected digit. The highest value of the available set of
values is followed again by the lowest.
Saving the value
F4 saves the set value and returns to display mode.
Canceling editing
F1 cancels editing and returns to display mode. All changes are discarded.
See also
Password management (Page 141)
Password protection (Page 49)