Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
621
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router vrrp
Result
Routing with VRRP is disabled.
Further notes
You enable routing with VRRP with the
router vrrp
command.
9.4.3
Commands in the VRRP Router Configuration mode
This section describes commands that you can call up in the VRRP Router Configuration
mode.
In the Global Configuration mode, enter the
router vrrp
command to change to this mode.
●
If you exit the VRRP Router Configuration mode with the
exit
command, you return to
the Global Configuration mode.
●
If you exit the VRRP Router Configuration mode with the
end
command, you return to the
Privileged EXEC mode.
9.4.3.1
interface
Description
With this command, you decide the interface for which you want to assign parameters in the
VRRP Router configuration mode.
There you can edit the settings for a VRRP interface. You select the VRRP interface with the
parameters of this command.
Note
This command is available only with layer 3.
Summary of Contents for SCALANCE XM-400
Page 882: ......
