Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
676
Configuration Manual, 06/2016, C79000-G8976-C252-11
9.6
RIPv2 (IPv4)
This section describes the commands relevant for working with routing with RIPv2.
RIPv2 is only used with IPv4 and is defined in RFC 2453. It is based on the distance vector
algorithm of Bellman-Ford.
RIPv2 uses the UDP port 520.
9.6.1
show ip rip
Description
This command shows the RIP information.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
or
cli#
Syntax
Call up the command with the following parameters:
show ip rip {database [<ip-address> <mask>] | statistic }
The parameters have the following meaning:
Parameter
Description
Range of values / note
database
The information of the RIP database is
displayed.
-
ip-address
The destination address of the route for
which information is displayed.
Specify a valid IP address.
mask
The subnet mask of this route.
Enter a valid subnet mask.
statistic
Statistical information is displayed, for
example the number of updates.
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The database or statistical information is displayed.
Summary of Contents for SCALANCE XM-400
Page 882: ......
