Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
678
Configuration Manual, 06/2016, C79000-G8976-C252-11
9.6.2.2
no router rip
Description
With this command, you disable the RIP protocol.
Note
This command is available only in layer 3 (IPv4).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router rip
Result
Routing with RIP is disabled.
Further notes
You enable the RIP protocol with the
router rip
command.
9.6.3
Commands in the RIPv2 Router configuration mode
This section describes commands that you can call up in the RIPv2 Router configuration
mode.
In the Global configuration mode, enter the
router rip
command to change to this mode.
●
If you exit the RIPv2 Router configuration mode with the
exit
command, you return to the
Global configuration mode.
●
If you exit the RIPv2 Router configuration mode with the
end
command, you return to the
Privileged EXEC mode.
Note
These commands are available only with layer 3.
Summary of Contents for SCALANCE XM-400
Page 882: ......
