Layer 2 management protocols
8.8 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
506
Configuration Manual, 06/2016, C79000-G8976-C252-11
8.8.2.7
no ipv6 mld snooping port-purge-interval
Description
With this command, you reset the setting for the purge time to the default value.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ipv6 mld snooping port-purge-interval
Result
The purge time is reset to the default value.
Further notes
You configure the setting with the
ipv6 mld snooping port-purge-interval
command.
You can display the status of this function and other information with the
show ipv6 mld
snooping globals
command.
8.8.3
Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
vlan $$$
command to change to this mode.
When doing this, you need to replace the
$$$
placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
●
If you exit the VLAN Configuration mode with the
exit
command, you return to the Global
Configuration mode.
●
If you exit the VLAN Configuration mode with the
end
command, you return to the
Privileged EXEC mode.
Summary of Contents for SCALANCE XM-400
Page 882: ......
