Diagnostics
12.3 Loop detection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
912
Configuration Manual, 06/2016, C79000-G8976-C252-11
12.3.1.1
show loopd
Description
With this command, you display the information on loop detection.
Detected loops are shown.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
or
cli#
Syntax
Call the command without parameters:
show loopd
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
Information on loop detection is displayed.
12.3.1.2
show loopd interface
Description
Displays information on the loop interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
or
cli#
Syntax
Call up the command without parameters or with the following parameter assignment:
show loopd interface [{<interface-type> <interface-id> | port-channel <port-channel-
id (1-8)>}]
Summary of Contents for SCALANCE XM-400
Page 882: ......
