Siemens MAG 1100, Operating Instructions Manual, Page: 308 / 665

Page 134 MultiRanger 100/200 – INSTRUCTION MANUAL 7ML19981FB05
mmm
mm
Pa
ra
m
e
te
rs
P110 Level Source
Sets the level source on which the indexed relay is assigned to a measurement point.
Please note that Difference and Average settings are MultiRanger 200 features
.
MultiRanger 200
Please note that these features are only available on the MultiRanger 200.
In Single Point Mode (standard):
Points 2 and 3 are available only if Operation is set for difference or average
(P001 = 4 or 5).
In Dual Point Mode (optional):
Point 2 is always available, and Point 3 is available only if Operation is set for difference or
average (P001 = 4 or 5).
P111 Relay Control Function
Sets the control algorithm used to trip the relay.
Please note that parameter P111 values vary between the MultiRanger 100 and the
MultiRanger 200.
Use zero
0
(preset) to disable control of the indexed relay.
Primary Index
Relay
Values
Range: 1 to 3
1 * Point # 1 = Transducer One
2 Point # 2 = Transducer Two
3
[MR 200]
Point # 3 = Difference (P001=4) or Average (P001=5)
[MR 200]
Altered by:
• P003 Maximum Process Speed
• P700 Max Fill rate
• P701 Max Empty rate
• P070 Failsafe Timer
• P071 Failsafe Material Level
Primary Index
Relay
Values
See chart below
Altered by
• P100 Preset Applications
Note:
All relay ON/OFF points must be referenced from Empty (P006), regardless
of Operation Mode selection (POO1).