Seneca S6001-RTU, User Manual

Page: 92 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
92
large amount of data is forwarded
from one interface to the other (LAN
↔ WAN).
Since this does not occur when the
two ethernet interfaces work in
“switch” mode, the parameter is not
shown when “Ethernet Mode”
parameter is set to “Switch” (see
paragraph 18.1.2).
Possible values are:
Unlimited
20 Mbit/s
10 Mbit/s
1 Mbit/s
DNS Enable Flag to enable/disable the DNS
forwarding service ON
DHCP Server Enable Flag to enable/disable the DHCP
service (DHCP server)
NOTE: this parameter can be set to
“ON” only if the “DHCP” parameter
of the “Network and Services” page
is set to “OFF”. OFF
DHCP First Address
DHCP Last Address These parameters define the range
of IP addresses assigned by the
DHCP server to requesting clients 192.168.90.201
192.168.90.210
DHCP Lease Time (min) Validity period for the IP address
assignment, in minutes.
Possible values are in the range
[1..60]. 15
Then, you have the parameter shown in the following table.
Field Meaning Default value
Use Local Addresses Through VPN Flag to enable/disable the access to
the Device and other devices which
are in the Device LAN by using their
local (LAN) IP addresses OFF
Then, you have another important parameter, which is shown in the following table.
Field Meaning Default value
Mobile Network Firewall/Enable Flag to enable/disable the “Mobile
Network
Firewall”, that is
disable/enable access to the Device
and other devices which are in the
Device LAN, by using the IP address
ON