Seneca S6001-RTU, User Manual

Page: 67 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
67
parameter, otherwise an error is
shown.
WATCHDOG/Enable Flag to enable/disable the
watchdog functionality
ON
WATCHDOG/Timeout (s) Watchdog timeout, in seconds;
when watchdog is enabled, if it’s
not refreshed for this amount of
seconds, the system will be
rebooted.
Possible values are in the range
[30..3600]. 60
DEBUG LOGS/Enable Flag to enable/disable the debug
logs OFF
COM1/Mode Operating mode of the COM1 serial
port; possible values: RS485,
RS232,
Z-MBUS (Meter Bus
extension)
RS232 and Z-MBUS parameters are
available only for Z-TWS4-IO and Z-
PASS2-S-IO products.
RS485
Some notes about the “DHCP” parameters:

the “DHCP” parameter can be set to “ON” only if the “DHCP Server” parameter of the “Router
Configuration” page is set to “OFF” (see paragraph 18.1.5);

only the “DHCP on WAN” parameter can be set to “ON”.
You can change any of the above parameters; to apply the changes, press the “APPLY” button; as warned
by the note on the page, only for some parameters, the parameter change requires rebooting the Device;
these parameters are:

NETWORK/Ethernet Mode

WEB SERVER/Port

WATCHDOG/Enable, only when changing ON -> OFF

DEBUG LOGS/Enable, only when changing ON -> OFF
If the “LOG FOLDER SHARING/Enable” parameter is ON, on a Windows PC, you can directly access the
“/log” directory, as shown in the following pictures (the sharing name is equal to the product name,
without ‘-‘ character, that is “ZPASS2S”, “ZTWS4” or “S6001RTU”):