Seneca S6001-RTU, User Manual

Page: 120 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
120
is “None”
Data Connection/Password Password needed for UMTS/GPRS
connectivity, as given by the Mobile
Network Operator; it may be empty,
if “Authentication Type” parameter
is “None” pass
Data Connection/Ping Connection
Testing IP Address (if empty, testing
is disabled) FQDN or IP address used to
periodically check, by means of
“ping” packets, if the mobile
connection is actually working; if the
field is lefty empty, the check is not
performed.
It is important to note that the
FQDN or IP address specified must
be reachable from the Device mobile
network, otherwise the Device will
detect that the mobile connection is
not working and will drop it. www.google.com
In the “Mobile Network” page, when you click on the “SHOW MOBILE STATUS” button, a new section
appears, named “Mobile Status”, showing:

the SIM/PIN Status; if an error in PIN setting has occurred or PUK/PUK2 setting is needed, this
status is shown in red color

the number of remaining attempts for PIN setting; when this value is less than 3 (shown in red
color), it means that PIN setting has failed, that is the configured PIN value is wrong

the radio “Signal Level”, in the range [0..7]

the selected operator (only for Z-PASS2-S-IO)

the GSM “Registration Status”

the Mobile Network “Connection Status” (i.e.: “Disconnected” or “Connected”)

the IP address assigned to the Mobile Network interface when connected, the “dummy” IP address
“0.0.0.0” when disconnected

the number of packets/bytes received from the Mobile Network interface, when connected; “0/0”
when disconnected

the number of packets/bytes sent to the Mobile Network interface, when connected; “0/0” when
disconnected
as shown in the following couple of figures: