Schweitzer Engineering SEL-351P, Quick Start Manual

Page: 529 / 674

Date Code 990430 Serial Port Communications and Commands 10-45
SEL-351P Manual Técnico
PUL Command (Pulse Output Contact)
The PUL command allows you to pulse any of the output contacts for a specified length of time.
The command format is:
PUL x y
where: x is the output name (e.g. OUT107, ALARM – see Figure 7.26).
y is the pulse duration (1 - 30) in seconds. If y is not specified, the pulse
duration defaults to 1 second.
To pulse OUT101 for 5 seconds:
=>>PUL OUT101 5 <ENTER>
Are you sure (Y/N) ? Y <ENTER>
=>>
If the response to the “Are you sure (Y/N) ?” prompt is “N” or “n”, the command is aborted.
The PUL command is supervised by the main board Breaker jumper (see Table 2.4 and
Table 2.5). If the Breaker is not in place (Breaker jumper = OFF), the recloser control does not
execute the PUL command and responds:
Aborted: No Breaker Jumper
The control generates an event report if any of the OUT101 through OUT107 contacts are
pulsed. The PULSE command is primarily used for testing purposes.
Access Level 2 Commands
Access Level 2 commands allow unlimited access to recloser control settings, parameters, and
output contacts. All Access Level 1, Access Level E (EZ), and Access Level B commands are
available from Access Level 2. The screen prompt for Access Level 2 is: =>>
CON Command (Control Remote Bit)
The CON command is a two-step command that allows you to control Relay Word bits RB1
through RB8 (see Row 26 in Table 9.4). At the Access Level 2 prompt, type CON, a space, and
the number of the remote bit you wish to control (1 - 8). The control responds by repeating your
command followed by a colon. At the colon, type the Control subcommand you wish to perform
(see Table SECTION 10: .7).
The following example shows the steps necessary to pulse Remote Bit 5 (RB5):
=>>CON 5 <ENTER>
CONTROL RB5: PRB 5 <ENTER>
=>>