scheider electric MiCOM P746, Technical Manual

Page: 73 / 530

Getting Started P746/EN GS/G31
MiCOM P746 (GS) 3-
35
GS
RP1 Protocol Opto I/P Status Global Nominal V Ctrl I/P Status Hotkey Enabled Fn Key Status
Courier 48/54V 0000000000000000 0000000000
RP1 Address Opto I/P Status 2 Opto Filter Ctrl Control Input 1 Control Input 1 Fn Key 1
00000000 1111111111111111 No Operation Latched Unlocked
RP1 InactivTimer Rly O/P Status Opto Filter Ctr2 Ctrl Command 1 Fn Key 1 Mode
15 mins 11111111 Set/Reset Normal
RP1 Card Status Test Port Status Characteristics Control Input 2 Fn Key 1 Label
K Bus OK 00000000 Standard 60%-80% Latched Function Key 1
RP1 Port Config Monitor Bit 1 Control Input 32 Ctrl Command 2 Fn Key 2
K Bus 64 No Operation Set/Reset Unlocked
If RS485: Monitor Bit 2 Fn Key 2 Mode
65 * Continue as above Toggled
RP1 Comms Mode up to Ctrl Input
IEC60870 FT1.2 and Ctrl Command Fn Key 2 Label
* Continue as above 32 Function Key 2
RP1 Baud Rate up to Monitor bit 8
19200 Control Input 31
Latched
* Continue as above
If Ethernet: up to function key
NIC Protocol Monitor Bit 8 Ctrl Command 31 10.
IEC61850 71 Set/Reset
NIC Mac Address Test Mode Control Input 32 Fn Key 10
00.02.86.92.01.4 Disabled Latched Unlocked
if "Contacts
NIC Tunl Timeout Blocked" Ctrl Command 32 Fn Key 10 Mode
5.000 mins Test Pattern Set/Reset Normal
0000000000000000 see section P746/EN T
NIC Link Report for the default settings. Fn Key 10 Label
Alarm Contact Test Function Key 10
No Operation
NIC Link Timeout
60.00 s
If Second rear port: Test LEDs
Loopback Mode No Operation
No Action
Red LED Status
Reload Mode 0000010001000000
No Action
Green LED Status
RP2 Protocol 0000010001000000
Courier
Test Zone
RP2 Card Status none
0
DDB 31 - 0
RP2 Port Config 0000000000000000
EIA232 (RS232)
DDB 63 - 32
RP2 Comms Mode 0000000000000000
IEC60870 FT1.2
RP2 Address
255
DDB 2015 - 1984
RP2 InactivTimer 0000000000000000
15
DDB 2047 - 2016
RP2 Baud Rate 0000000000000000
19200 bits/s
Msg Reject Count
0
Report Link Test
Alarm
0000000000000000
* Continue as above up
to Control input 32
FUNCTION KEYS
(When Visible)
CTRL I/P CONFIG
(When Visible)
CONTROL INPUTS
(When Visible)
OPTO CONFIG
COMMISSION TESTS
(When Visible)
0000000000000000
1111111111111111
6
COMMUNICATIONS
(If set visible)
If "Test Mode"
or disabled
Link Time Out
60.0 s