52
TSA-SA70 OWNER’S MANUAL
4
5
Repeat step 3 at the other end of
the angle guide rail
(D)
, so the whole
rail is flush with the top surface of
the sliding table. Re-check both
ends of the angle guide rail (front
and back) to make sure they are still
correct. Then tighten the two bolts.
Thread a lock handle
(2.11)
into the
smaller, threaded hole in a T-nut
(2.10)
.
D
3
Lay a straight edge or square across
the sliding table top
(M)
so that it
extends over the top of one end of
the angle guide rail
(D)
. Make sure
the angle guide rail is level with the
sliding table top, then use a 10mm
wrench to snug the exposed hex
head bolt on the inside edge of the
left side of the sliding table.
M
M
D
D
WITH
WITHOUT
EXTENSION WING
OR
2.11
2.10
