67
TSA-SA70 OWNER’S MANUAL
Step 3 requires two people.
i
4
5
Use a 13mm wrench to tighten the
hex head bolt closest to the front of
the saw and to loosen the hex head
bolt closest to the rear of the saw.
Make sure the sliding table top is
parallel to the top of the saw table
(and extension wing, if installed) and
then adjust the foot pads on the
bottom of the three installed support
legs until the sliding table top is
between 0.010” and 0.020” higher
than the table saw top.
Repeat step 2, but lay the straight
edge across the sliding table top
near the rear of the mounting
bracket.
3
WITH
WITHOUT
EXTENSION WING
OR
