13
TSA-SA70 OWNER’S MANUAL
INSTALLING YOUR LARGE
SLIDING TABLE
Shortening the Rails WITH the Extension Wing
PAGES:
13-66
1
2
Mark the front rail and main tube 1 1/4” to the right of the left edge of the left
extension wing. If shortening the rear rail, mark the rear rail 1/4” to the right of the
left edge of the extension wing.
Use a 13mm wrench to remove the bolts from the underside of the main tube.
Set it aside.
3
4
Use a 13mm wrench and 5mm hex wrench to remove the front rail (and rear rail if
shortening rear rail).
Use a metal cutting band saw or a hack saw with a metal cutting blade to cut off
the front rail and main tube (and rear rail if shortening rear rail) at the marks made in
step 1.
USING OTHER TYPES OF SAWS (SUCH AS A CIRCULAR SAW) CAN
GENERATE ENOUGH HEAT TO BLISTER THE POWDER COATING. IT IS
STRONGLY SUGGESTED THAT YOU USE A METAL CUTTING BAND SAW
OR A HACK SAW WITH A METAL CUTTING BLADE ONLY.
WITH EXTENSION WING
Modifying your table saw to install the Large Sliding Table WITH the Left
Extension Wing:
You will need to shorten your
front
rail to mount the sliding table attachment with the left
extension wing, so proceed to step 1 below.
If the left end of the
rear
rail does not extend past the left edge of the extension wing,
then no modification is necessary for the rear rail. Complete the assembly of your saw
and rear rail as specified in your fence manual.
If, however, the left end of the
rear
rail does extend past the left edge of the extension
wing, then you will need to shorten your rear rail, so continue to step 1 below.
