42
TSA-SA70 OWNER’S MANUAL
1
2
3
Use a 13mm wrench to loosen the
four hex head bolts
(1.37)
attaching
the outer guide tube
(B)
to the two
stepped leg brackets
(H)
.
Place a firm piece of material (i.e.
plywood or the wider end of a blade
spacing adjustment gauge) with
1/8”-3/16” thickness at each end of
the sliding table, between the edge
of the sliding table
(M)
and the inner
guide tube bearing channel
(A)
.
Push against the outer edge of the
table
(M)
until it presses against the
material from step 2. This will also
cause the rail and bolts to move
relative to the slotted holes in the
stepped leg mounting brackets
(h)
.
There should be about 1/8”-3/16” of clearance between the sliding table and the
inner guide tube bearing channel. If there is, then skip this step. If there is not, you
will need to adjust the spacing, so proceed to step 1 below.
Adjusting the Spacing
B
H
M
M
A
H
H
WITH
WITHOUT
EXTENSION WING
OR
1.37
1.37
