29
TSA-SA70 OWNER’S MANUAL
Installing the Sliding Table Support Assembly
For installations WITH OR WITHOUT the extension wing.
Requires:
Hardware Bag 3 (p.5)
Drill
Hardware Bag 5 (p.6)
Two 13mm Wrenches
1
2
3
Mount the frame support bracket
(1.50)
to the remaining two threaded
holes in the bottom of the inner
guide tube
(A)
, just in front of the
support leg
(F)
, using two hex head
bolts
(1.11)
and two washers
(1.10)
.
Use a 13mm wrench to tighten the
bolts.
Align the mounting holes in the outer
tube of the support tube
(K)
with the
mounting hole in the bottom surface
of the frame support bracket
(1.50)
.
Make sure the lock nut on the outer
tube is facing up.
With the mounting holes aligned,
insert a hex head bolt
(1.44)
through
a washer
(1.10)
, then through the
exposed holes in the frame support
bracket
(1.50)
and support tube
(K)
,
and then through a second washer
(1.10)
and a lock nut
(1.39)
.
Do not
fully tighten the lock nut at
this time.
A
K
K
F
WITH
WITHOUT
EXTENSION WING
OR
1.50
1.50
1.50
1.44
1.10
1.39
1.10
1.11
1.10
Installation of the sliding table support assembly is recommended but optional. To install the
sliding table support assembly, follow the procedure starting with step 1 below. If you do not
wish to install the sliding table support assembly, skip this section and proceed to page 32.
