12
TSA-SA70 OWNER’S MANUAL
DISCONNECT YOUR TABLE SAW FROM ELECTRICAL POWER BEFORE
BEGINNING ANY MODIFICATIONS.
MODIFYING YOUR TABLE SAW
Before mounting the Large Sliding Table, you may need to modify your table saw.
Some of the steps below involve removing/installing your rails, switchbox, and extension
wing. For those steps, please refer to your table saw manual and fence manual. (You can
download copies of your manuals at www.sawstop.com.)
For Unassembled Saws
: If your saw has not yet been assembled, you will first need to
pre-install the rails to mark them for cutting.
• If you plan to mount the Large Sliding Table with the left extension wing, begin
by installing and aligning the left extension wing as described in the installation
documentation for your table saw.
• If you plan to mount the Large Sliding Table without the left extension wing, then do
not install the wing for this step.
• Next, install your rail assembly to the saw as described in your fence manual. It is not
necessary to install every screw or to fully align and tighten your rails at this time.
• Now proceed to page 13 if you plan to install the Large Sliding Table with the left
extension wing.
• Alternatively, proceed to page 15 if you plan to install the Large Sliding Table without
the left extension wing.
