23
TSA-SA70 OWNER’S MANUAL
Attaching the Large Sliding Table Positioning Plate
For installations WITH OR WITHOUT the extension wing.
Requires:
Hardware Bag 2 (p.4)
6mm Hex Wrench
1
2
Position th
e po
sitioning plate
(I)
on the mounting bracket
(E)
, such
that the square holes for the lateral
brackets (shown by the red arrows)
are towards the rear of the saw.
The positioning plate can be attached to the mounting bracket in three configurations: front,
center, and rear. Attach the positioning plate with either 2 or 4 socket head cap screws from
hardware bag 2 depending on which configuration you choose, as shown by the red arrows
in the diagrams below. The instructions below will be based on the center configuration.
Align the two elongated mounting
slots in the positioning plate
(I)
with the four mounting holes in the
mounting bracket
(E)
, then thread
four socket head cap screws
(1.36)
with four washers
(1.10)
through the
sliding table positioning plate
(I)
and
into the exposed mounting holes in
the sliding table mounting bracket.
I
E
I
E
WITH
WITHOUT
EXTENSION WING
OR
1.36
1.10
FRONT CONFIGURATION
CENTER CONFIGURATION
REAR CONFIGURATION
