15
TSA-SA70 OWNER’S MANUAL
Shortening the Rails WITHOUT the Extension Wing
1
2
3
Find the seam between the table and the left extension wing (or the left edge of the
table if the wing is not installed). Mark the front rail and main tube 1 1/4” to the right
of the seam (or edge). Mark the rear rail 1/4” to the right of the seam (or edge).
Use a 13mm wrench to remove the bolts from the underside of the main tube. Set
it aside.
Use a 13mm wrench and 5mm hex wrench to remove the front and rear rails.
4
5
6
7
For PCS ONLY:
if you have not yet mounted the switch box assembly to your saw,
skip to step 6 below. If your switch box assembly has already been mounted to
your saw, use an hex wrench to remove the two bolts that mount the switch box
bracket to the main table. Allow the switch box assembly to dangle in place.
If the wing is already installed, use either a 17mm wrench (for ICS) or 13mm wrench
(for PCS) to remove the left extension wing from the table saw.
Use a metal cutting band saw or a hack saw with a metal cutting blade to cut off
the front rail, rear rail, and main tube at the marks made in Step 1.
Remove any burrs or sharp edges with a file.
USING OTHER TYPES OF SAWS (SUCH AS A CIRCULAR SAW) CAN
GENERATE ENOUGH HEAT TO BLISTER THE POWDER COATING. IT IS
STRONGLY SUGGESTED THAT YOU USE A METAL CUTTING BAND SAW
OR A HACK SAW WITH A METAL CUTTING BLADE ONLY.
WITHOUT EXTENSION WING
Modifying your table saw to install the Large Sliding Table WITHOUT the Left
Extension Wing:
You will need to shorten your rails to mount the sliding table attachment without the left
extension wing, so proceed to step 1 below.
