22
TSA-SA70 OWNER’S MANUAL
E
3
4
5
5
For PCS saws ONLY:
With the
mounting holes aligned, and the top of
the mounting bracket
(E)
about 1/16”
below the top surface of the table,
insert a M8 x 1.25 x 30 hex head bolt
(1.37)
through a washer
(1.7)
, then
through one of the four exposed holes
in the mounting bracket
(E)
and the
table. Only finger tighten the bolt at
this time.
For ICS saws ONLY:
Repeat step 2 for
the other two sets of exposed holes.
For PCS saws ONLY:
Repeat step
3 for the other three sets of exposed
holes.
Check to make sure the mounting
bracket is somewhat level, then use a
13mm wrench to tighten the bolts.
WITHOUT EXTENSION WING
1.37
1.7
