SATEL INT-GSM
27
Commands
Commands list
– commands assigned to the currently highlighted macro command. The
and
buttons allow you to change the order of commands (moving the selected
command up and down).
Add
– click to add to the list a new command, selected in the “Command” field.
Change
– click to save the changes to the command parameters which were made after
adding the command to the list (otherwise, the changes made will not be saved).
Delete
– click to remove the highlighted command from the list.
Command
– the control panel executed function which can be assigned to the macro
command. The list of all available functions will be displayed after you click the
button.
Depending on which function you choose:
Arming
– select the partitions which are to be armed (double-click on the field designated
by the partition number) and define the arming mode (next clicks on the field designated
by the partition number; the digit inside the field has the following meaning: 0 - full
arming; 1 – full bypasses; 2 – arming without interior; 3 - arming without
interior and without entry delay).
Disarming
– highlight the partitions which are to be disarmed (double-click on the field
designated by the partition number).
Alarm clearing
– select the partitions in which alarm is to be cleared (double-click on the
field designated by the partition number).
Bypass zones
– select the zones which are to be inhibited (double-click on the field
designated by the zone number).
Unbypass zones
– select the zones which are to be unbypassed (double-click on the field
designated by the zone number).
Outputs ON
– select the outputs which are to be activated (double-click on the field
designated by the output number).
Outputs OFF
– select the outputs which are to be deactivated (double-click on the field
designated by the output number).
Change outputs state
– select the outputs whose status is to be changed (double-click
on the field designated by the output number).
KNX telegram
– program the following parameters of KNX telegram for the INT-KNX
module:
INT-KNX
module
– INT-KNX module which is to send the telegram.
Group address
– the group address which will be inserted in the telegram.
Type
– the telegram type.
Value
– the value that will be inserted in the telegram (parameter available for some
types of the telegram).
Priority
– telegram priority (if two elements of the bus start transmitting simultaneously,
the telegram with higher priority will be sent first).
KNX telegram (v2)
– program the following parameters related to setting the value of KNX
communication object:
Module INT-KNX
– INT-KNX-2 module in which the value is to be set.
Makro Command
– name of the “Virtual (macro)” type object, defined in INT-KNX-2
module.
Data type
– size and meaning of the communication object data defined in INT-KNX-2
module for selected object.