14 INT-GSM
SATEL
Lock time
– the time during which switch-over to the other SIM card is impossible. The time
is counted from the moment of switch-over to the given card. For reporting, the
transmission paths programmed as subsequent ones, if they require switch-over to the
other card, will be skipped during the lock time countdown. Entering the value 0 means
that instant switch-over to the other SIM card is possible.
Return time
– the time after which the other SIM card is to be used. Entering the value 0
means that automatic switch-over to the other SIM card will not take place.
If two SIM cards are to be used, one of them must be treated as the priority card. It is
recommended that return time equal to 0 be programmed for it.
SMS for sending USSD code
– control command that will be sent in the SMS message
together with USSD code. The control panel will run the USSD code and send the
response received from the operator to the phone number from which the SMS message
with control command was sent. You can enter up to 16 alphanumeric characters (digits,
letters and special characters).
The command content must be different from that of the other control commands.
The SMS message with the USSD code must look like this: “xxxxxx=yyyy=”, where:
“xxxxxx” - control command, “yyyy” – USSD code supported by the GSM network
operator.
It is not advisable to use the advanced functions available due to the USSD service if
menu is presented in response to the entered code.
The control command for sending USSD codes can be used for sending SMS
messages through the control panel.
USSD codes from any number
– if this option is enabled, the control command for sending
the USSD codes or checking the SIM card balance (see “Check balance SMS” p. 16) can
be sent from any telephone. If the option is disabled, the command can only be sent from
the telephone whose number is stored in the module (see “SMS messaging / CLIP control”
p. 16).
Time from GSM network
– if this option is enabled, the control panel clock can be
synchronized with the time of the GSM network operator.
Do not report LAN trouble if INT-GSM connected to SATEL server
– the option is
available if the INT-GSM module is connected to the ETHM-1 Plus module. If this option is
enabled, loss of the Ethernet network will not be reported, when connection has been
successfully established with the SATEL server via the INT-GSM module (GPRS).
Do not report LAN trouble if INT-GSM connected to SMTP server
– the option is available
if the INT-GSM module is connected to the ETHM-1 Plus module. If this option is enabled,
loss of the Ethernet network will not be reported, when connection has been successfully
established with the SMTP server via the INT-GSM module (GPRS).
Do not report LAN trouble if INT-GSM connected to NTP server
– the option is available if
the INT-GSM module is connected to the ETHM-1 Plus module. If this option is enabled,
loss of the Ethernet network will not be reported, when connection has been successfully
established with the NTP server via the INT-GSM module (GPRS).
SMS
SMS initiating DLOADX connection
– the control command which, if sent in the SMS
message, will initiate communication between the alarm control panel and the DLOADX
program via:
INT-GSM module connected to the control panel (GPRS),