SATEL INT-GSM
15
ETHM-1 Plus module to which the INT-GSM module is connected (Ethernet). If
connection cannot be established over Ethernet, an attempt will be made to establish
communication via GPRS.
You can enter up to 16 alphanumeric characters (digits, letters and special characters).
SMS initiating GUARDX connection
– the control command which, if sent in the SMS
message, will initiate connection between the alarm control panel and the GUARDX
program via:
INT-GSM module connected to the control panel (GPRS),
ETHM-1 Plus module to which the INT-GSM module is connected (Ethernet). If
connection cannot be established over Ethernet, an attempt will be made to establish
communication via GPRS.
You can enter up to 16 alphanumeric characters (digits, letters and special characters).
The content of control commands must vary.
The content of one control command must not be inserted into the content of another
command.
You can include in the SMS message the address of computer the module is to
connect to, and the number of TCP port to be used for communication. Such
a message should look like this: xxxx=aaaa:pp= (“xxxx” – control command; “aaaa” –
address of the computer (IP address or domain name); “pp” – port number).
5.2.2 Pre-paid support
Fig. 11. DLOADX program: “Pre-paid support” tab.
SIM 1 / SIM 2
USSD-check balance
– the USSD code which is used to check balance of the SIM card
account. If the code has been programmed, the module can check the SIM card account
balance.
Minimum level
– the minimum amount of funds on the SIM card account. If the amount of
funds drops below the minimum level:
trouble will be reported,