Page 43
FUncTiOn PagE F2
When the Dial Knob is programmed to control AUX1 (Auxiliary Channel 3), and you choose AUX1 or AUX 2 to be the
MASTER channel, by setting the OFFSET value to 100 or -100, the Dial Knob can be adjusted so that no mixing occurs
when the Dial Knob is turned all the way in one direction, but full mixing will occur when the Dial Knob is turned in the other
direction. This is useful if you don't want mixing in both directions of travel. In the example below, set the AUX1 MASTER H
percentage value to 50% (or other desired value), set the AUX1 MASTER L percentage value to 0%, then set the OFFSET value
to 100. When the Dial Knob is turned counter-clockwise, no mixing will occur. However, when the Dial Knob is turned clockwise,
full mixing will occur.
1) Press the ENTER key to move the cursor to OFFSET, then press the
INC/+ or DEC/- keys to adjust the desired OFFSET value.
C-MIX C-MIX1 OFFSET setting range is -150 to 150. The default setting is 0.
Using a positive or a negative value determines the direction of OFFSET.
0
MAX
Dial
Knob
H: 50%
L: 0%
MASTER
SLA
VE
H
B
L value is set to 0% since no operation
occurs on the L side with an OFFSET.
Since no operation occurs beyond 100 when the MASTER is set to AUX1 or AUX2, this can be set to 100.
Compensation Mixing ACT/INH Setting
1) To use the C-MIX1 function, it must be Activated. Press the ENTER key
to move the cursor to C-MIX, then press the INC/+ or DEC/- keys to either
ACT (Activate) or INH (Inhibit) the C-MIX1 function.
The C-MIX1 ACT/INH setting can be assigned to any Push-Button
switch using the Key Assign function. For more information, see
page 49. By using this function, switching C-MIX1 ON or OFF can be
selected during model operation.
The C-MIX2 ACT/INH setting can be assigned to any Push-Button switch using the Key Assign function. For more
information, see page 49. By using this function, switching C-MIX2 ON or OFF can be selected during model operation.
1) Press the Function key to move the cursor to [C-MIX2] in the C-MIX
Programming Window. The cursor will default to ST1.
2) Use the same techniques that you used to adjust the programming values
for C-MIX1 to adjust the desired programming values for C-MIX2.
In addition to being able to be controlled separately, both the C-MIX1
and the C-MIX2 functions can be Active at the same time, if desired.
[C-MIX2] COMPENSATION MIXING 2
Follow the steps below to program C-MIX2.
FuNCTION P
AGE F2
Summary of Contents for ExzesX
Page 1: ...Page 1 ...