SAIC MG 6, Service Manual

Page: 57 / 357

Instruments and Controls
• Wiper Delay Switch （ 5 ）
• Programmed Wash/Wipe （ 6 ）
Intermittent wipe
Push the lever (1) up to select the intermittent wipe, wipers
will wipe automatically.
Rotate the switch (5) to vary
the intermittent time of wiper operation. Intermittent
operation time of wipers will also be amended according to
road speed - increased road speed will reduce intermittent
operation time.
Normal Speed Wipe
Push the lever (2) up to select the normal speed wipe,
wipers will wipe at normal speed. If the road speed drops
below 5 MPH (8 km/h) while the wipers are operating, they
will slow to the next slowest operating mode; i.e. fast wipe
to normal wipe, normal wipe to intermittent. This facility
can be manually overridden by changing the wipe setting.
Fast Speed Wipe
Push the lever (3) up to select the fast speed wipe, wipers
will wipe at high speed. If the road speed drops below
5 MPH (8 km/h) while the wipers are operating, they will
slow to the next slowest operating mode; i.e. fast wipe to
normal wipe, normal wipe to intermittent. This facility can
be manually overridden by changing the wipe setting.
Single Wipe
Pull the lever (4) down and release, wipers will wipe once.
If the lever is held down, the wipers will operate at high
speed until the lever is released.
Programmed Wash Wipe
Pull the lever (6) towards the steering wheel - the washers
operate immediately. After a short delay, the wipers will
commence operating in conjunction with the washers,
both functions continuing until the lever is released. The
programmed wash wipe function can be disabled; refer to
section ‘Prog Wash Wipe’ of ‘Main Menu’ in the Chapter
‘Message Centre’.
39
1