SAIC MG 6, Service Manual

Page: 37 / 357

Instruments and Controls
When the ignition is in position Ⅱ , the different trip
computer functions can be selected as follows:
•
Low line models (A)
: Short press (< 2 seconds)
the button on the end of the direction indicators/main
beam lever to select the trip computer function. Use a
long button press (> 2 seconds) to enter the menu from
the trip computer or to enter a highlighted function.
•
High line models (B)
: Use the left-hand
thumbwheel to scroll up and scroll down to select the
trip computer function or to highlight a menu item.
Press the left-hand thumbwheel to enter the menu
from the trip computer or to enter a highlighted menu
item.
Note: The trip computer item will be replaced by the
warning message once the waning message displayed
when using trip computer.
At this moment, the
previous trip computer item can be displayed again
by pressing the button on the end of the direction
indicators/main beam lever (low line) or scroll the
thumbwheel (high line).
The following information will be displayed.
• Next Service
• Fuel Consumption
• Range to Empty
• Average Fuel
• Average Speed
• Trip 1
• Trip 2
The trip computer functions can be set displayed or not.
Refer to ‘Vehicle Information Display’ in this chapter.
Next Service
The message centre shows the distance remaining before
the next service is due and the estimated date that it will
be due on. This display appears for 4 seconds every time
the ignition is switched to position
Ⅱ .
The distance display commences at 7500 km and
progressively reduces in increments of 50 km as the car is
driven, until zero is reached. The relevant service should
be carried as soon as the distance display shows zero.
After the completion of each service, the distance display
will be reset to 7500 km.
Note: Because the service interval display reduces in
increments of 50 km, it is possible to undertake a
19
1