Sagem MF 3725, User Manual

Page: 63 / 152

Setting your machine
3-9
Date en cours : 9 février 2005
C:\Documents and Settings\G097447\Bureau\MFK V2 LU 251 816 433A MF 3725 GB\Configuration Gb.fm
So
mmaire
Insta
lla
tio
n
Op
er
atio
n
Se
ttin
g y
our
ma
ch
in
e
Ge
tting
sta
rte
d
Direc
to
ry
Mai
nte
na
nce
Sa
fe
ty
C
ont
en
ts
Insta
lla
tio
n
Prin
t f
un
ction
Repeatedly press the keys or until O
PTIONAL
appears.
Press E
NTER
.
Press the > key.
This example shows how to switch the TCP/IP protocol on to connect the terminal to the
network. You can switch Netware or EtherTalk on in the same way.
If TCP/IP is OFF. Press E
NTER
, a blinking "?" appears. Select ON using the or keys.
Press E
NTER
again.
Automatically configuring IP settings
You can make these settings when the TCP/IP protocol is on. We recommend that you manually
configure your terminal. However, local network settings can be automatically configured if you
have a DHCP or BOOTP server on your local network which can dynamically distribute
addresses to peripherals on the LAN.
To automatically configure network local settings:
MENU - - INTERFACE > - - TCP/IP > DHCP
Press E
NTER
, a blinking "?" appears.
Select ON using the or , then press E
NTER
.
Press the M
ENU
key.
Switch your terminal off and then back on again. You have now finished configuring the
IP address
Manually configuring IP settings
You can make these settings when the TCP/IP protocol is on.
To configure your terminal manually, you will need the usual information for setting up a
peripheral (IP address, subnet mask and gateway address).
To manually configure network local settings:
MENU - - INTERFACE > - - TCP/IP > DHCP
Check that DHCP is set to O
FF
. If not press E
NTER
, then select O
FF
with the or . keys
Press E
NTER
.
Press .
Press E
NTER
to enter the IP address. A cursor (_) starts to flash in the right-hand segment
(3 figures). Press the key to increment the value and the key to decrement it. Once
you have set the value for the right-hand segment, press the < key to place the cursor in the
next segment. Again, press the key to increment the value and the key to decrement
it. Proceed in the same way for all of the segments. Press E
NTER
once all the segments have
been set up.
Press .
Enter the subnet mask address in the same way as for the IP address.
Press .
Enter the gateway's IP address in the same way as for the IP address.