Sagem MF 3725, User Manual

Page: 61 / 152

Setting your machine
3-7
Date en cours : 9 février 2005
C:\Documents and Settings\G097447\Bureau\MFK V2 LU 251 816 433A MF 3725 GB\Configuration Gb.fm
So
mmaire
Insta
lla
tio
n
Op
er
atio
n
Se
ttin
g y
our
ma
ch
in
e
Ge
tting
sta
rte
d
Direc
to
ry
Mai
nte
na
nce
Sa
fe
ty
C
ont
en
ts
Insta
lla
tio
n
Prin
t f
un
ction
Manual configuration
To configure your terminal manually, you should obtain the usual information used to set a
peripheral device (IP address, sub-network mask, network and gateway address).
To configure the local network setting manually:
2531 OK - SETUP / NETWORKS / LOCAL NETWORK / CONFIGURATION
Choose
MANUAL
and press
OK
to confirm.
IP address
2532 OK - SETUP / NETWORKS / LOCAL NETWORK / IP ADRESSE
Enter the IP address of your terminal and press OK to confirm.
Sub-network mask
2533 OK - SETUP / NETWORKS / LOCAL NETWORK / SUBNET MASK.
Enter the sub-network mask of your terminal and press OK to confirm.
Gateway address
2534 OK - SETUP / NETWORKS / LOCAL NETWORK / GATEWAY
Enter the IP address of the network gateway and press OK to confirm.
IEEE address (or Ethernet address) or MAC address
2535 OK - SETUP / NETWORKS / LOCAL NETWORK / IEEE ADRESSE
The Ethernet card of your terminal already has an unmodifiable, yet consultable, IEEE address.
NetBIOS
The NetBIOS name, which can be used with the network options, are used to identify your
terminal machine from a PC connected to a local network (for instance with the name
"IMP-NETWORK-1"
2536 OK - SETUP / NETWORKS / LOCAL NETWORK / NETBIOS 1
2537 OK - SETUP / NETWORKS / LOCAL NETWORK / NETBIOS 2
Enter the selected name (15 characters max) and press OK to confirm.
The WINS1 and WINS2 servers, used with the network options, allow access to terminals on
other sub-networks by means of their NetBIOS name.
These two addresses must be filled in for the Scan To Disk function.
2538 OK - SETUP / NETWORKS / LOCAL NETWORK / SRV. WINS 1
2539 OK - SETUP / NETWORKS / LOCAL NETWORK / SRV. WINS 2
Enter the IP address of each server, then validate with OK .
Remark : If the terminal is set up in Automatic configuration mode ( 2531), these addresses can be filled in auto-
matically by certain DHCP servers.