Ruijie Networks RG-S8605E, Hardware Installation And Reference Manual

Page: 98 / 132

Figure 3-40 Installing the QSFP+ Module Equipped with a Pull Tap
3) Use the fiber optical patch cord to connect the 40G QSFP+ module to the fiber optical network. Select the patch cord
with the connector corresponding to the port.
4) After the patch cord is connected, the Link/ACT Status LED is on. Otherwise, please check connection of the patch
cord.
Precaution
 Pay attention to the proper end of the QSFP+ module for installation. If the QSFP+ module cannot be inserted to the
end, do not push it forcefully. Please try the other end of the module.
 It is recommended that you do not remove the protective rubber plug from QSFP+ module before connecting fibers.

It is recommended that you do not insert the QSFP+ module with a fiber into the slot. Unplug the fiber before
installing the module.
 Do not touch the connecting finger on the module.
 Do not squeeze, bend or fold the optical fiber, which may cause system performance degradation or data loss.
Installing 40-Gigabit QSFP+ Cables
To avoid damaging components due to operation errors, read this section carefully before installing
40-Gigabit QSFP+ copper cables.
Take the following steps to install 40-Gigabit QSFP+ copper modules:
1) You can install the QSFP+ copper module with power on. Hold the connector of a copper cable module with one
hand and carry the cable to the front panel of the switch with the other. Push the module gently into the QSFP+
module slot until you hear a click, indicating the module is correctly installed.
Figure 3-41 Installing the QSFP+ Copper Module