Ruijie Networks RG-S8605E, Hardware Installation And Reference Manual

Page: 117 / 132

In order to ensure the reliability of the system ventilation and heat dissipation performance and address the
requirement of the dust-filter, filler panel needs to be installed in the slot where no supervisor module or
service module has been installed.
If you want to remove the module when the device is electrified, you need to insert the new module or install
the filler panel within 10 minutes.
Do not hold the edge of the PCB or collide the components on the PCB
Do not plug/unplug a supervisor module or service module forcedly, use the ejector.
Removing Power Modules
Preparation
1) Wear an anti-static wrist strap close to your skin and have it properly grounded.
2) Take out the power module from the package.
3) Please power off the module before removing it.
After hot swapping a module, please wait for at least 30 seconds for the next operation.
Before inserting or removing the power module, please verify whether the switch is well mounted. Prevent
the switch from tumbling down when you are inserting or removing the power module.
Do not touch the connecting finger on the power module which has been removed to avoid being
electrocuted in case of incomplete discharge.
Take the following steps to remove the power module:
1) Unplug the cable. Separate the pigtail plug of the cable from the connector of the power module.
2) Unloosen the captive screws on the power module with the screwdriver.
3) Pull out the handle to make it vertical from the power panel.
4) Drag the power module panel with one hand and support the bottom of the power module with the other hand to pull
out the power module.
5)
Insert the power module into the slot until it hits the back panel.
6) Drive the handle close to the panel.
7) Tighten the captive screws on the panel with the screwdriver.
Figure 7-13 Removing the Power Module