Ruijie Networks RG-S8605E, Hardware Installation And Reference Manual

Page: 115 / 132

Figure 7-9 Removing the QSFP+ Cable
Precaution
 Pull the tap out before unplugging the cables. Otherwise, the module or the slot can be damaged.
 Immediately install the dust plug to the module port and the switch fiber port.
Replacing Modules
Preparation
1) Wear an anti-static wrist strap close to your skin and have it properly grounded.
2) Take out the module from the package.
Take the following steps to replace the module:
1) Unplug all cables/fibers such as fibers and RJ45 twisted pairs from the panel.
2) Hold down self-locking lever buttons on both sides of the panel and pull out the lever.
3) Drag the lever to pull the module out, Before the module is about to be removed from the chassis, support the bottom
of the module with one hand and hold the module with the other hand, so as to prevent the module from falling.
4) Pull out the levers on both sides of the module. Support the bottom of the module with one hand and hold the module
with the other hand to insert the module into the slot along the rail.
5) Drive the levers close to the module, and the module will hit the back panel. The module will be fastened after
self-locking of levers.
Figure 7-10 Replacing the Module (for RG-S8605E)
Figure 7-11 Replacing the Module (for RG-S8607E)