Instalattion and operating manual: MGSM 5.0/MGSM 5.0-PS v.1.8S EN
Remarks:
•
after cutting off the power supply, the module clock is reset to 2000.01.01,
00:00 hours 00.00
•
the module restart is permitted by using an SMS RESTART message. This
command is not acknowledged with a restore message.
e.g. The module restarting SMS:
xxxx RESTART,
where xxxx – access code (e.g. adam)
•
CLOCK CORRECTION
– if the internal module clock reading differs from the real
value, the daily average should be computed and set in the bookmark. This function
p/- 120 seconds time compensation per day.
The clock correction can be also
performed by using the CORRECTION SMS.
e.g. the clock correction SMS:
xxxx CORRECTION zyyy
, where xxxx – access code (e.g. adam), z – correction
character (+ or -), yyy – correction value in seconds
(example: adam CORRECTION –10 = 10 seconds per 24 hours delay)
•
SMS CONTENT
SMS content to be sent as test information (“GSM module OK” by
default) should be entered in the bookmark.
Remarks:
•
the maximum number of characters 20, do not enter national characters
•
the module can be tested via an SMS message by sending the module access
code - if the code is identical to the one in the module memory, it will reply by
sending a test SMS.
e.g. „test on demand”:
xxxx
, where xxxx – access code (e.g. Adam) (example: adam = reply: GSM module OK
6.5.2 FAILURES
The module permanently monitors the value of the supply voltage. If the supply voltage,
measured at module supply terminals (+12V, GND), falls below the value of 11 VDC (or returns
above the value of 11V), such information can be sent via an SMS message.
•
SUPPLY FAILURE
- the SMS content signaling a power supply drop below 11V should be
entered in the bookmark.
•
SUPPLY RESTORE
- the SMS content signaling a power supply restore above 11V should
be entered in the bookmark.
•
NO AC SUPPLY
– enter the SMS message content corresponding to the decay of AC
voltage
(MGSM 5.0-PS only)
in the tab. The time of signalization delay is configured in
the DELAY [min] tab (in 5s – 1,000min range).
•
AC SUPPLY RETURNED
enter the SMS message content that signals the return of AC
supply voltage in the tab.
Remarks:
•
The ALARM SMS content is sent only to the first telephone number (entered in
the „NUMBERS” bookmark).
•
Only one information can be entered and a missing SMS implies that no
message regarding a given event will be sent.
6.5.3 COUNTERS
The number of sent SMS messages and the number
of telephone calls can be set in this bookmark. Counters
may serve to limit costs during failures of input devices
(damaged alarm sensor, power supply failure etc.).
•
SMS COUNTER –
determines the maximum
28
