Instalattion and operating manual: MGSM 5.0/MGSM 5.0-PS v.1.8S EN
•
the module is designed to send „human voice” and DTMF formats
•
Ropam Elektronik does not hold any responsibility for failures of GSM network
e.g. „busy network”, lack of GSM signal etc.
•
11.2. ALARM, FAILURE signaling at the TIP-RING output
The module enables alarm state of failure signaling by generating “ring” signal and voice message
(as in case of incoming calls, VSR-2 is required). If functions are activated (GSM GATE bookmark):
„
RING AND VSR-2 MESSAGE WHEN ALARM”
„
RING AND VSR-2 MESSAGE WHEN FAILURE”
then the module at the TIP-RING output, it means on the analogue telephone, will generate
signals:
●
ALARM-
the module generates the „ring” tone and after picking up the receiver, it will
play the audio message (VSR-2) assigned to a particular event (module input, see the
INPUTS bookmark)
●
FAILURE-
the module generates the „ring” tone and after picking up the receiver, it
will play the audio message (VSR-2) assigned to a particular failure (signaling in
accordance with the FAIL diode).
The voice massage is in the following form “
F”FAILURE NUMBER”
, where
the failure number is:
1 – weak signal of GSM network below 2 “dashes”
2 – telephone isn't logged in the network
3 - failed 3 attempts of SMS sending per series
4 – low supply voltage U<11V at the supplying input
5 – overload input 01 (I>1A)
6 - lack of communication with the industrial telephone module
7 – PIN code failure
8 – SIM card problem
12. DEFAULT SETINGS
PARAMETER
No./DESCRIPTION
(PARTNER GSM
software)
FACTORY SETTINGS
PIN
Not required
ACCES CODE
1111
RETURN
ACKNOWLEDGEMENT
active
PASSWORD
123B, Downloading: not set
INPUTS
I1
I2
I3
I4
I5
I6
I7
I8
NO,INFO,500ms
NO,INFO,500ms
NO,INFO,500ms
NO,INFO,500ms
NO,INFO,500ms
NO,INFO,500ms
NO,INFO,500ms
NO,INFO,500ms
SEND SMS TO
I1
I2
I3
TEL1, TEL2, TEL3 TEL4
TEL1, TEL2, TEL3 TEL4
not set
53
