Instalattion and operating manual: MGSM 5.0/MGSM 5.0-PS v.1.8S EN
7 – PIN code error,
8 – problem with SIM card,
10 – rapid flashing signifies configuration data damage in EEPROM memory
PROGRAMMING (communication with PC):
– flashes every ca. 0.5 second = module firmware update (communication active)
●
INCOM:
NORMAL STATE
- no lit = lack of activity of incoming calls
- lit = incoming calls or SMS
PROGRAMMING (communication with remote PC ):
- lit = connecting with remote PC via CSD (modem link)
9. MODULE CONTROL AND STATUS
The module enables remote control of the following options: armed mode, blocking of inputs,
outputs (MGSM 5.0, PSR-RF), reading an operational status.
9.1.
Remote control of MGSM 5.0 module status:
•
The control function of the armed mode via SMS is realized by sending an SMS message with
the following content:
Command (yyyy = access
code)
Description
Example
ARM yyyy
Armed the module
1234 ARM
DISARM yyyy
Disarmed the module
1234 DISARM
9.2. Selected inputs locking
Any input on the device can be locked/unlocked remotely by sending an SMS command in the
following form:
Command (yyyy = access code)
Description
Example
yyyy LOCK I1I2I3I4I5I6
I7I8
Activation of the mask for blocking
module inputs, until the armed mode is
deactivated or module is reset.
If the position I1…I8 = 1, then the
module blocks the particular input.
If the position I1…I8 = 0, then the
module ignores the particular input
during blocking (its functions remain
unchanged)
1234 LOCK 10000000
The I1 input will be
blocked
yyyy UNLOCK
All blocked inputs are unblocked
UNLOCK 1234
All inputs are
unblocked
9.3. Remote control of output status: MGSM 5.0
It is done by CLIP or SMS messages. Output parameters are configured in the OUTPUTS tab.
CLIP control consists in carrying out the connection with a telephone number. Depending on
the configuration, the module can confirm control execution.
46
