Instalattion and operating manual: MGSM 5.0/MGSM 5.0-PS v.1.8S EN
include maximum to nine characters (figures and special characters e.g. '+','*')
6.6.3 ANALOGUE TELEPHONE OPTIONS
These options are used for configuration of telephone line output operation (GSM gate) depending
on: occurring incoming connection, module state.
•
RING FOR INCOMING CALLS –
marking this option causes passing every incoming call
to the output of simulated telephone line TIP-RING and enables conversation on the
phone (standard telephone)
•
RING AND VSR-2 MESSAGE WHEN ALARM –
marking this option causes audio
signaling at TIP-RING output (activating the ring and voice message after picking up the
receiver) for every alarm at the system input. The audio message is in accordance with
the configuration in the INPUTS bookmark (required VSR-2 module)
•
RING AND VSR-2 MESSAGE WHEN FAILURE -
marking this option causes audio
signaling at the TIP-RING output (activating the ring and voice message after picking up
the receiver) for every failure in the system. The voice message is in the following form:
“
FAILURE” + “FAILURE NUMBER”
where the following numbers mean (they are in
accordance with the FAIL signaling diode)
1 – weak signal of GSM network below 2 “dashes”
2 – telephone isn't logged in the network
3 - failed 3 attempts of SMS sending per series
4 – low supply voltage U<11V at the supplying input
5 – overload input 01 (I>1A)
6 - lack of communication with the industrial telephone module
7 – PIN code failure
8 – SIM card problem
•
ARM/DISARM FUNCTION ENABLED CONTROL FROM TELEPHONE KEYPAD
marking this options enables control over module arming via the DTMF code.
•
DISABLE PHONE WHEN ARMED
–
marking this option causes total switching off the
TIP-RING output during the module armed mode. Telephone line module is switched on
after switching off the standby mode (e.g. input, remote control, SMS from a mobile
phone, DTMF from a mobile phone).
6.6.4 VOLUME REGULATION IN A TELEPHONE
Options are used for adjusting audio signal quality on the track of GSM gate. In majority default
settings are suitable and they do not need to be corrected.
•
MIC GAIN –
it is used for setting the telephone microphone amplification. Regulation
available by moving a “slider”. Regulation range from 0 to 15 (default setting=3). If the
amplification is too strong, there might appear “echo” and interferences while voice
connection.
•
EARPIECE VOLUME –
it is used for setting the volume level in the telephone
speaker. Regulation available by moving a “slider”. Regulation range from 0 to 99
(default setting=99).
6.6.5 ON-LINE
Commissioning and testing configuration bookmark. The following functions are
available from the PARTNER GSM software level:
•
monitoring of module inputs status
•
monitoring of module outputs status (activation)
•
entering the module SIM card PIN code
•
module date and clock synchronization with PC computer
•
module telephone status monitoring (logged in or not)
•
monitoring of GSM network signal level status
32
