4-5
I/S MENU
CARTRIDGE
CARTRIDGE
IC CHECK
IC CHECK
SLOT1 INSERT
CARTRIDGE
SLOT 1
SL1 : CAPACITY
400cc
SL1 : CONSUM.
100.000cc
SL1 : TIME
0y000d00h00m00s
CARTRIDGE
SLOT 2
SL1 : SERIAL
1402A30C010000A5
SL1 : INK TYPE
Max K
SL1 : LOT NO.
40216A
SL1 : INSERT
1 times
SL1 : FLAG
000000000
IC CHECK
SLOT1 ERROR
CARTRIDGE
SLOT 12
SLOT1
NO CARTRIDGE
SLOT1
NO IC CHIP
SLOT1
SYSTEM ERROR
SLOT1
DATA ERROR
IC CHECK
SLOT1 OK
IC CHECK
SLOT12 INSERT
IC CHECK
SLOT12 ERROR
IC CHECK
SLOT12 OK
IC CHECK
COMPLETED
IC CHECK
SYSTEM ERROR
IC CHECK
COMPLETED
IC CHECK
SLOT1 ERROR
Remove all cartridges
before pressing ENTER
Set cartridge to SLOT1
Normal
Set cartridge to SLOT12
Normal
Error
From SLOT1 to 12 in order
Serial No. of the Ink Cartridge IC is displayed.
Ink type of the Ink Cartridge IC is displayed.
Ink capacity of the Ink Cartridge IC is displayed.
Lot No. of the Ink Cartridge IC is displayed.
Ink consumption of the Ink Cartridge is displayed.
The used time of the Ink Cartridge is displayed.
The insert count of the Ink Cartridge is displayed.
The Flag information of the Ink Cartridge is displayed.
Data error
System error due to the trouble such as a damage of driver IC placed on INK TANK BOARD
A cartridge with no IC is inserted, wire break or short
Ink cartridge is not inserted
It reads the information written on the IC of each carriage.
Following messages are displayed when some error is found.
All cartridges must be removed before entering IC
CHECK menu.
It detects Ink Cartridge IC, writes and loads information,
and checks the communication. First of all, it confirms
if there is the driver for IC detection. The following
display indicates that error is found on driver.
Next, IC communication is checked individually by SLOT.
When a cartridge is inserted, it automatically starts to
communicate with the cartridge IC and checks it. Display
shows [OK], when the communication is done properly.
As cartridge is removed, the next cartridge SLOT number
to be inserted is displayed. Starting from SLOT1, it
continues to SLOT12 in order. When the check of
SLOT12 is completed, the following message is
displayed at the end of check.
It returns to IC CHECK menu by pressing ENTER key.
When communication is failed, it displays as below.
It returns to IC CHECK menu by pressing ENTER key.
*Any cartridge can be used for this check as long as it
has IC chip on it.
*No information is written on IC chip during this check.
(Normally, the count of the cartridge installation is
written. However, the count of the installation in this
check is not written.)
*Before this IC check, make sure Cartridge Sensor is
working properly.
Error
