Roland JUNO-Di Editor, Owner'S Manual

Page: 59 / 92

59
Detailed Editing for a Performance (PERFORM Parameters)
MIXER
Parameter Value Explanation
PART 1–16
SOLO
OFF, ON Switch this to ON if you want to hear the part by itself.
MUTE OFF, ON
Mutes or un-mutes (OFF) each part.
Use this setting when, for example, you want to use the instrument for karaoke by muting
the part playing the melody, or when you want to play something using a separate sound
module.
* The MUTE parameter does not turn the part off, but sets the volume to minimum so that no
sound is heard. Therefore, MIDI messages are still received.
CATEGORY —
Type (category) of the patch
* “NO ASSIGN” can’t be selected on the JUNO-Di itself.
PREV
(Preview)
OFF, ON If you switch this to ON, you’ll be able to hear a preview sound played by that patch.
CHORUS
(Chorus Send Level)
0–127 Level of the signal sent to chorus for each part
REVERB
(Reverb Send Level)
0–127 Level of the signal sent to reverb for each part
OUTPUT
(Part Output Assign)
MFX,
L+R,
L, R,
PAT
Specifies for each part how the direct sound will be output.
MFX:
Output in stereo through multi-effects. You can also apply chorus or reverb to the
sound that passes through multi-effects.
L+R: Output in stereo to the OUTPUT jacks without passing through the multi-effect
L:
Output in mono to the OUTPUT L jack without passing through the multi-effect
R: Output in mono to the OUTPUT R jack without passing through the multi-effect
PAT:
The part’s output destination is determined by the settings of the patch or rhythm set
assigned to the part.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through the chorus is set with the
CHORUS OUTPUT SELECT parameters (p. 17).
MFX
(Part Output MFX Select)
1–3 Multi-effect used by the part (choose one of MFX 1–3)
LEVEL
(Part Output Level)
0–127 Level of the signal that is sent to the output destination specified by OUTPUT.
PAN
L64–0–63R Left/right position of each part
LEVEL 0–127
Volume of each part
This setting’s main purpose is to adjust the volume balance between parts.
MASTER * These settings are SYSTEM parameters (p. 14)
CONTROL CHANNEL
MFX 1–3
1–16, OFF
Specify the reception channel that will be used when using MFX control to control the multi-
effect parameter in real time, when MFX 1–3 SOURCE (p. 20) is set to “PERFORM.”
Leave this “OFF” if you’re not using MFX control.
* This parameter is not available in Patch mode.
MASTER LEVEL
0–127 Volume of the entire JUNO-Di