14
SYSTEM Parameters
]
COMMON
Parameter
Value
Explanation
MASTER LEVEL
0–127
Volume of the entire JUNO-Di
MASTER TUNE
415.3–466.2 Hz
Overall tuning of the JUNO-Di
The display shows the frequency of the A4 note (center A).
PATCH REMAIN
OFF, ON
Specifies whether currently sounding notes will continue sounding when another patch or
rhythm set is selected (ON), or not (OFF).
When this is “ON,” changes produced by incoming MIDI messages such as Volume or
Pan (CC 5, 7, 10, 65, 68, 71–74, RPN 0, 1, 2, MONO ON, POLY ON), as well as
tonal quality and volume changes produced by the various controllers will be inherited.
* Effects settings change as soon as you switch to a new patch or rhythm set, without being
influenced by the Patch Remain setting. Because of this, certain effects settings can cause
notes that were until then sounding to no longer be heard, even though Patch Remain has
been set to “ON.”
MASTER KEY SHIFT
-24–+24
Shifts the overall pitch of the JUNO-Di in semitone steps.
PERFORM CTRL CH
(Performance Control
Channel)
1–16, OFF
Selects the MIDI receive channel used during switching of performances when MIDI
messages (Program Change/Bank Select) are sent from an external MIDI device.
Set this to “OFF” if performances are not to be switched from an external MIDI device.
* If only a program change is received, and if this parameter setting coincides with the
MIDI receive channel of a part, priority will be given to switching the performance.
PATCH RX/TX CH
(Patch Rx/Tx Channel)
1–16
Channel used to transmit and receive MIDI messages for the Keyboard part in Patch mode
RCV PC
(Receive Program Channel)
OFF, ON
Specifies whether Program Change messages will be received (ON) or not (OFF).
RCV BS
(Receive Bank Select)
OFF, ON
Specifies whether Bank Select messages will be received (ON) or not (OFF).
SYSTEM CTRL SRC 1–4
(System Control Source 1–4)
OFF, CC01–95,
PITCH BEND,
AFTERTOUCH
Selects the MIDI message used as the System Control.
OFF:
The system control knob will not be used.
CC01–95:
Controller numbers 1–95
PITCH BEND:
Pitch Bend
AFTERTOUCH:
Aftertouch
System Control
This function, which departs from previously used methods, and instead allows you to use MIDI messages to change tone settings in realtime, is
called the
Matrix Control
the
Multi-effects Control
Normally, the Matrix Control is used for making patch settings, and the Multi-effects Control for making settings to patches, rhythm sets, and
performances.
System Control
applies to the entire JUNO-Di.
For example, if you want the same MIDI message to always be used for matrix control for other patches as well, select that MIDI message as
SYSTEM CTRL SRC 1, and select “SYS-CTRL 1” as the CONTROL SOURCE for the other patches. With these settings, even if you need to change
the MIDI message used for matrix control, all you need to do is simply choose a different MIDI message as the SYSTEM CTRL SRC 1. In other
words, you could call the System Controls global Matrix Control/Multi-effects Control for the entire JUNO-Di.
You can use up to four System Controls.
