49
Detailed Editing for a Rhythm Set (RHYTHM Parameters)
TVA
Parameter
Value
Explanation
LEVEL
0–127
Volume of the rhythm tone
This setting is useful primarily for adjusting the volume balance between rhythm ones.
PAN
L64–0–63R
Left/right position of the rhythm tone
AMP ENV A
(Amp Envelope Attack)
0–127
TVA envelope times
Higher settings will lengthen the time until the next volume level is reached.
This will modify ENV T1 (p. 55).
AMP ENV D
(Amp Envelope Decay)
0–127
TVA envelope times
This will modify ENV T3 (p. 55).
AMP ENV S
(Amp Envelope Sustain)
0–127
TVA envelope levels
Specify how the volume will change at each point, relative to the LEVEL value.
This will modify ENV L3 (p. 55).
AMP ENV R
(Amp Envelope Release)
0–127
TVA envelope times
This will modify ENV T4 (p. 55).
SEND LEVEL OUT
(Output Level)
0–127
Level of the signal that is sent to the output destination specified by OUTPUT ASSIGN
SEND LEVEL (OUTPUT ASSIGN = MFX)
CHO (Chorus Send)
0–127
Level of the signal sent to chorus for each rhythm tone if the tone is sent through MFX
REV (Reverb Send)
0–127
Level of the signal sent to reverb for each rhythm tone if the tone is sent through MFX
SEND LEVEL (OUTPUT ASSIGN = non MFX)
CHO (Chorus Send)
0–127
Level of the signal sent to chorus for each rhythm tone if the tone is not sent through MFX
REV (Reverb Send)
0–127
Level of the signal sent to reverb for each rhythm tone if the tone is not sent through MFX
OUTPUT ASSIGN
MFX,
L+R,
L, R
Specifies how the direct sound of each rhythm tone will be output.
MFX:
Output in stereo through multi-effects. You can also apply chorus or reverb to the sound
that passes through multi-effects.
L+R:
Output in stereo to the OUTPUT jacks without passing through the multi-effect
L:
Output in mono to the OUTPUT L jack without passing through the multi-effect
R:
Output in mono to the OUTPUT R jack without passing through the multi-effect
* If the OUTPUT ASSIGN in “RHYTHM COMMON” is set to anything other than “TONE,” these
settings will be ignored.
* Sounds are output to chorus and reverb in mono at all times.
* The output destination of the signal after passing through the chorus is set with the CHORUS
