38
Detailed Editing for a Patch (PATCH Parameters)
AMP ENV (TVA ENVELOPE)
Parameter marked with a “
★
” can be controlled using specified MIDI messages.
OUTPUT
Parameter
Value
Explanation
TIME KF
(TIME Keyfollow)
-100–+100
Use this setting if you want the TVA envelope times (T2–T4) to be affected by the keyboard location.
Based on the TVA envelope times for the C4 key (center C), positive (+) settings will cause notes higher
than C4 to have increasingly shorter times, and negative (-) settings will cause them to have
increasingly longer times. Larger settings will produce greater change.
T1 SENS
-63–+63
This allows keyboard dynamics to affect the T1 of the TVA envelope.
If you want Time 1 to be speeded up for strongly played notes, set this parameter to a positive (+)
value. If you want it to be slowed down, set this to a negative (-) value.
T4 SENS
-63–+63
Use this parameter when you want key release speed to affect the T4 value of the TVA envelope.
If you want T4 to be speeded up for quickly released notes, set this parameter to a positive (+) value.
If you want it to be slowed down, set this to a negative (-) value.
T1–4
★
(Time 1–4)
0–127
TVA envelope times (T1–T4)
Higher settings will lengthen the time until the next volume level is reached.
L1–3
(Level 1–3)
0–127
TVA envelope levels (L1–L3)
Specify how the volume will change at each point, relative to the LEVEL value.
Parameter
Value
Explanation
SEND LEVEL OUT
(Output Level)
0–127
Level of the signal that is sent to the output destination specified by OUTPUT ASSIGN
SEND LEVEL (OUTPUT ASSIGN = MFX)
CHO (Chorus Send)
0–127
Level of the signal sent to chorus for each tone if the tone is sent through MFX
REV (Reverb Send)
0–127
Level of the signal sent to reverb for each tone if the tone is sent through MFX
SEND LEVEL (OUTPUT ASSIGN = non MFX)
CHO (Chorus Send)
0–127
Level of the signal sent to chorus for each tone if the tone is not sent through MFX
REV (Reverb Send)
0–127
Level of the signal sent to reverb for each tone if the tone is not sent through MFX
OUTPUT ASSIGN
MFX,
L+R,
L, R
Specifies how the direct sound of each tone will be output.
MFX:
Output in stereo through multi-effects. You can also apply chorus or reverb to the sound that passes
through multi-effects.
L+R:
Output in stereo to the OUTPUT jacks without passing through the multi-effect
L:
Output in mono to the OUTPUT L jack without passing through the multi-effect
R:
Output in mono to the OUTPUT R jack without passing through the multi-effect
* If the PATCH OUTPUT ASSIGN is set to anything other than “TONE,” these settings will be ignored.
* If “STRUCTURE” (p. 30) is set to TYPE 02–10, the settings for tone 1 (3) will follow the settings of tone
2 (4). (This is because the outputs of tones 1 and 2 are combined into tone 2, and the outputs of tones
3 and 4 are combined into tone 4.)
* Sounds are output to chorus and reverb in mono at all times.
* The output destination of the signal after passing through the chorus is set with the CHORUS OUTPUT
T1 T2
T3
T4
L3
L1 L2
Note off
Level
TVA Envelope
Time
Note on
C4
C3
C2
C1
C5
C6
C7
0
+50
+100
-50
-100
Key
Time
Time Keyfollow
