Command Reference
R&S
®
CMW-KN5xx
86
User Manual 1176.7690.02 ─ 05
Suffix:
<Band>
.
14,30,50,100,150,200
Channel bandwidth in 0.1 MHz
Parameters:
<OBWlimit>
Range:
0 MHz to 40 MHz
*RST:
Equals the channel bandwidth, ON
Default unit: Hz
Additional parameters: OFF | ON (disables the limit check | ena-
bles the limit check using the previous/default limit values)
Example:
See
Firmware/Software:
V3.0.20
CONFigure:LTE:MEAS<i>:ENB:MEValuation:LIMit:SEMask:LIMit<no>:
CBANdwidth<Band>
<Enable>, <FrequencyStart>, <FrequencyEnd>,
<LevelAbsolute>, <SlopeAbsolute>, <LevelRelative>, <RBW>
Defines emission mask area number <no>. The emission mask applies to the channel
bandwidth <Band>.
See also
chapter 3.7.3, "Spectrum Emission Mask"
Suffix:
<Band>
.
14,30,50,100,150,200
Channel bandwidth in 0.1 MHz
<no>
1..10
Number of the emission mask area
Parameters:
<Enable>
OFF | ON
Disables / enables the limit check for the emission mask area
*RST:
ON (<no> = 1 to 3) / OFF (<no> = 4 to 10)
<FrequencyStart>
Start frequency of the area, relative to the edges of the channel
bandwidth
Range:
0 MHz to (35.91 - <Band>/20) MHz
*RST:
depends on <no> and <Band>
Default unit: Hz
<FrequencyEnd>
Stop frequency of the area, relative to the edges of the channel
bandwidth
Range:
0 MHz to (35.91 - <Band>/20) MHz
*RST:
depends on <no> and <Band>
Default unit: Hz
<LevelAbsolute>
Power component for calculation of the upper absolute limit line
of the area
Range:
-256 dBm to 256 dBm
*RST:
depends on <no> and <Band>
Default unit: dBm
Multi Evaluation Measurement Commands
深圳德标仪器
135-1095-0799
