Rievtech PR-12 Series, User Manual And Programmers Manual

Page: 24 / 260

17
3.1 DIN rail mounting
Mounting
How to mount a xLogic module and an expansion module onto a DIN rail:
1. Hook the xLogic Basic module onto the rail.
2. Push down the lower end to snap it on. The mounting interlock at the
rear must engage.
3. Hook the xLogic expansion module onto the rail
4. Slide the module towards the left until it touches the xLogic CPU.
5. Push down the lower end to snap it on. The mounting interlock at the
rear must engage.
6. Remove the plastic cover in the expansion port of CPU and expansion
module.
7. Plus the connector on the flat cable to CPU
Repeat the expansion module steps to mount further expansion modules.
Note:If you need install the expansion and CPU on different rows, you need
order the longer flat connection which is used to connected with CPU, the
longest distance can be 200meters between the CPU and the end expansion
module.
Removal
To remove xLogic:
if you have installed only one xLogic Basic:
1.Insert a screwdriver into the eyelet at the bottom of the slide interlock
and move the latch downward.
2. Swing the xLogic Basic off the DIN rail.