Rievtech PR-12 Series, User Manual And Programmers Manual

Page: 25 / 260

18
if you have connected at least one expansion module to xLogic Basic:
1. Remove the connector on the flat cable
2. Slide the expansion module off towards the right.
3. Insert a screwdriver into the eyelet at the bottom of
the slide interlock and lever it downward.
4. Swing the expansion module off the profile rail.
Repeat steps 1 to 4 for all other expansion
modules.
3.2 Wall-mounting
For wall-mounting, first slide the mounting slides on the rear side of
the devices towards the outside. You can now wall-mount xLogic by means
of two mounting slides and two Ø M4 screws (tightening torque 0.8 to 1.2
Nm).
Drilling template for wall-mounting
Before you can wall-mount xLogic, you need to drill holes using the
template shown below.
All dimensions in mm
Bore hole for Ø M4 screw, tightening torque 0.8 to 1.2 Nm