Ricoh D0C8, Service Manual

Page: 1416 / 1647

Printer Service Mode
D0CA/D0C9/D0C8/D0CB 3-424
SM Appendices
1001 Bit Switch
008 Bit Switch 8 0 1
bit 0
to 2
DFU - -
bit 3 BW Printing without the PJL Color Command
"DATAMODE"
Disabled Enabled
This setting enables a job to be printed in BW without the PJL color command
"DATAMODE".
Note: Color jobs will not be printed without the PJL color command "DATAMODE".
Note:This is available for PCL, PS only.
bit 4
to 5
DFU - -
bit 6 Orientation Auto Detect Function (PS) Enabled Disabled
Automatically chooses page orientation of PostScript jobs (Landscape or Portrait)
based on the content.
PJL/PDL Color Command Priority PJL Priority PDL Priority
This setting enables the priority of a PDL color command to be changed when a
PJL color command is "@PJL RENDERMODE = GRAYSCALE" in a job.
Note:This is available for PCL,RPCS,PS.
bit 7 [PDF]: Orientation Auto Detect Function Enabled Disabled
Automatically chooses page orientations of PDF jobs (Landscape or Portrait)
based on the content.
1001 Bit Switch
009 Bit Switch 9 0 1
bit
0
PDL Auto Detection timeout of jobs submitted
via USB or Parallel Port (IEEE 1284).
Disabled
(Immediately)
Enabled
(10 seconds)
To be used if PDL auto-detection fails. A failure of PDL autodetection does not
necessarily mean that the job can not be printed. This bit switch tells the device
whether to time-out immediately (default) upon failure or to wait 10 seconds.
bit
1
DFU - -
bit
2
Job Cancel after Jam Not cancelled Cancelled
This setting enables it to be specifed whether jobs will be cancelled after a jam
occurs.
Note: If this BitSw is enabled, printing under the following conditions might result in
problems:
- Job submission via USB or Parallel Port