Remote Control Commands
R&S
®
NRX
222
User Manual 1178.5566.02 ─ 05
[SENSe<Sensor>:]BWIDth:VIDeo:LIST?
[SENSe<Sensor>:]BANDwidth:VIDeo:LIST?
Queries the parameters available for
[SENSe<Sensor>:]BANDwidth:VIDeo
.
Suffix:
<Sensor>
.
1 to 128
Configured sensor connected at: port A = 1, ... , port D = 4, R&S
NRX-B9 = 101, USB and LAN port = 5 to 100
Usage:
Query only
[SENSe<Sensor>:]TRACe:MEASurement:AUTO[:STATe]
<value>
Enables or disables the automatic transfer of the measured pulse parameters after
each trace. If enabled, the trace and pulse data in a continuous measurement with
INITiate<Measurement>:CONTinuous
ON
are synchronously displayed.
For pulse measurements, enable this setting.
Suffix:
<Sensor>
.
1 to 128
Configured sensor connected at: port A = 1, ... , port D = 4, R&S
NRX-B9 = 101, USB and LAN port = 5 to 100
Parameters:
<value>
*RST:
OFF
[SENSe<Sensor>:]TRACe:MEASurement[:STATe]
<value>
Enables or disables automatic pulse measurements. If pulse measurement is on, the
sensor automatically determines the pulse parameters for the currently measured
trace. For pulse measurements, also set
[SENSe<Sensor>:]TRACe:MEASurement:
.
Suffix:
<Sensor>
.
1 to 128
Configured sensor connected at: port A = 1, ... , port D = 4, R&S
NRX-B9 = 101, USB and LAN port = 5 to 100
Parameters:
<value>
ON | OFF
*RST:
OFF
[SENSe<Sensor>:]TRACe:REALtime
<state>
If disabled, each measurement from the sensor is averaged. If enabled, the averaging
of each measurement is disabled and thus the measurement speed is increased. With
a higher measurement speed, the measured values of an individual measurement are
immediately delivered.
Measurement Settings and Results